V4.94 Digiprog III Digiprog3 Odometer Master Programmer .

Best Quality V4.94 Digiprog III Digiprog3 Odometer Master Programmer Entire Kit

Top 4 Reasons to Get Low Cost V4.94 Digiprog 3

1. Latest Version: V4.94
2. This is newest version Digiprog3 with most competitive price.
3. With ST01 ST04 Adapter in the Package
4. Supported Languages: Deutsch, English, Espanol, French, Portuguese, Italiano, Turkish, Nederlands

Notice:
 1. Power-On Password: 1
2. If you want to upgrade your digiprog 3, need to return the main unit for upgrading

Digiprog 3 V4.94 Add Car Model List:

Audi :
-A3 new version
Ford :
-F150 24C16
-Falcon 24c02
Mercedes :
-W176 new version
-W204 new version Diag
-W212 new version Diag
Opel :
-Insignia new version
-Astra new version
V4.93 digiprog 3 odometer programmer:
 
For Audi :
A3 Diag new version
A6 Diag new version
A8 Diag new version
For Mercedes :
R 172 Diag new version
R 231 Diag new version
W 212 Diag new version
For Ford :
Kuga Transit
For VW :
Amarok Polo Johnson

Digiprog 3 V4.94 Features:

1. Service interval adjustments and settings 
     Assyst processing
     Fault memory read-erase
     EEPROM programmer
     Integrated PC communication

Digiprog 3 How to use ?

1.Turn off your engine and locate the "Function" button on the front of DigiProg III Mileage correction tool
2.Press and hold the "Function" button while turning the engine on. DigiProg III Mileage correction tool will now enter calibration mode.
3.Press the "Function" button repeatedly to scroll through the options until you come to "Auto."
4.Press and hold the switch until "-" is displayed. Release the switch when this appears. "Unit" will now appear on the display.
5.Wait until "Cal" appears on the display followed by zeroes, then drive your automobile until one mile clicks over on DigiProg III Mileage correction tool
6.Stop the car and then press and release the "Function" button. The mileage is now set.
 
Some Important Tips for Using Digiprog 3:
1. Always connect the Eeprom to the ST01 or ST04 before you connect to the DigiProg this will avoid Electro static feedback (ESD).
2. Never solder the connections whilst the lead is connected to the programmer, this will damage the DigiProg.
3. Always keep your DigiProg in its case when not in Use & keep it in a dry environment at night (don’t leave it in the trunk of your car) If you are using solvents to remove lacquers’ from Eeprom’s ensure that they are cleaned 4. completely as the solvent can damage the clips.